Crappie Fishing Article
Drift Fishing For Crappie.
A Productive
Way To Catch Big Crappie
By Mark Fleagle
Best Location To Drift Fish For Crappie.
The Hardest part about catching crappie while drift fishing is
locating the schools. You will need a topographical map of
the area, and should have a good depth, fish finder. You can pick
the topographical map up at the local bait store. (It\'s advisable
to go there to get the latest fishing report anyway.) Crappie
school in open water and if you can find the schools you can
catch a good batch of crappie. Also it has been my experience
, the crappie you catch in open water while drift fishing seem
to be bigger. The first step you should before you get out
on
the water is locate the deepest part of body of water you are
fishing on from your topographical map, this will be your starting
point. You will be fishing the break area\'s on the bottom
surface. To Locate a break area look for changes in depth on your
depth
finder. Any break deep to shallow, or shallow to deep are good
spots to drift. Try to avoid any flat dead pan bottom surface
areas. You will just waist your time in these areas
How to Set Your Drift for Crappie Fishing
Locate the winds direction
and set you boat in position to drift along the break. (change
in bottom depth) Make sure your boat drifts along the deeper
side of the break. You will use your trolling motor to keep your
drift
in position along the deep side of the break. If you don\'t have
a trolling motor your have to use you boat motor to get back
in position. (this can spook the fish, that's why a trolling motor
is recommended. The Depth finder will be your guide to stay along
the deep side of the break, and to locate the fish. Set up a
weighted
crappie rig to just touch bottom with sinker position your baits
about 18 to 24 inches off the bottom. As you drift, watch the
rod tip, it will bounce up and down slightly as the weight drags
along
the bottom. If the tip of the rod remains still the sinker is
not in contact with the bottom. When you catch the first fish drop
one of your marker buoys to mark the spot. Continue to drift
until
another fish is caught or about 75 yards, then drop another buoy.
This marks your drift location for a return drift or anchor position.
Drift about 50 more yards past the second buoy then start up
your boat motor and go around the buoys approximately 75yards away.
Know move your boat back in position for another drift. Normally
the school will be concentrated in one area. Keep working the
spot
until you get no more bites. If your lucky you can catch your
limit in a short time. Equipment you will need:
Boat with a trolling motor
Marker buoys
Light Spinning Tackle
Crappie rigs
Jigs
You can use this technique on any body of water so have fun!
And good luck -
Article written by Mark Fleagle
www.oldfishinghole.com
Fishing Articles -
Catch crappie by drift fishing.
|